We have been asked to quote to make some bath drain wastes and have to buy in the foam washer that sits between the top of the waste and above hard plastic washer. I am assuming the shore hardness is crucial to establish the waste will not leak? The washer is white foam, I assume is some sort of EPDM but how do I ensure we install the correct type if I don't have a shore hardness established?
Can I get any information about recent trends or new developments in packaging?
I am looking for an expert academician who would be willing to help me improve the quality of a review paper I am writing for submission to quality journal. My superior in Malaysia reserves the right to be the corresponding author but if any academician would be interested to help us then he/she may be the first author of the work. The manuscript needs significant scientific touch up.
I am looking to have a prototype made for a belt strap on Jag Car. the strap core is made from Hytrel 7246. My question is this. Is there a material that can be machined and that will have enough flexibility in it to withstand being bent and twisted like a strap in test.
I AM TRYING TO DEVELOP A NEW PLASTICS PRODUCT.I HAVE NO KNOWLEDGE OF YOUR INDUSTRY.
I REQUIRE A SHEET OF VERY THIN PLASTIC.
THREE FEET THREE INCHES WIDE BY THREE FEET HIGH. ON BOTH SIDES AND ON THE BOTTOM I WISH TO FORM A ONE AND HALF INCH BEND.
MY SHEET OF PLASTIC IS NOW THREE FEET WIDE BY TWO FEET TEN AND HALF INCHES HIGH.
I NOW WISH TO HEAT SEAL THREE,TWELVE INCH WIDE SECTIONS OF DIFFERENT COLOURED PLASTIC BAG TYPE PLASTIC MATERIAL TO THE INCH AND HALF BEND AREA.
CAN ANY PLASTICS MANUFACTURER HELP.
MR WILLIAM LLOYD